Radium Engineering Crankcase Catch Can Kit

20-0316

Focus RS 2016-2018

Supplied exclusively by Radium Engineering, their Crankcase Catch Can Kit for the Ford Focus RS attaches to the high pressure fuel pump (HPFP) mount on the back of the cylinder head. Because the ST uses a different HPFP than the RS, this kit is only compatible with the RS .

This catch can runs inline with the crankcase breather port. At low loads it experiences atmospheric pressure, but when the engine is at high load (WOT), this hose will experience high flow out of the crankcase. This would normally lead to oil and sludge accumulation in the air filter intake pipe. Oil accumulation will occur in the intercooler which lowers the thermal efficiency properties of the heat exchanger and leads to decreased performance.

For the ultimate in engine protection for your RS, we recommend the 20-0328 Dual Catch Can System. The 20-0328 kit utilizes both the "Crankcase" and "PCV" catch can kits.

Add the Radium Catch Can Drain Kit for easy service, click here.

Prevents oil buildup in the intake and intercooler system walls, throttle body, intake manifold, etc.
Excessive oil collection can be an indicator of a damaged engine.
Lowers hydrocarbon emissions
Capacity: 6 fluid ounces each
Easy installation

WARNING:

This part has been designed and is intended for off-highway application only. Installation of this part on a vehicle that is driven on public roads may violate U.S. and Canadian laws and regulations relating to emission requirements and motor vehicle safety standards. Click Here for Emissions compliance information.