mountune MR300 Focus ST Performance ECU Calibration
This option is for MP275 Focus ST customers who have all the required MR300 hardware (including an mTune) but
require an in-field firmware update to their existing handset.
Your mTune can be easily
upgraded from MP275 to MR300 Performance calibration specifications. This
update is for those that have already purchased the correct components to
support the calibration. Simply order online and you will be sent update
instructions by email along with a Digital Key that allows you to upgrade you
mTune from MP275 to MR300. In-field firmware updates are facilitated via a
bespoke upgrade key. Once ordered we will send you steps to follow in order for
you to provide us with your specific mTune serial number. A key will then be
generated and sent to you which will enable you to update your mTune's firmware
using the AP Manager software.
When ordering, please
include your mTune FMP serial number in the comment section of the order form.
The serial number can be found underneath the face plate of your mTune.
Required hardware list:
• mountune alloy intercooler
• mountune induction kit
• mountune high-flow
induction hose
• mountune charge pipe
upgrade kit
• mountune cat-back exhaust
Please note: Installing the
MR300 calibration without the correct hardware list above may result in failure
to make the quoted power / torque figures, abnormal running, detrimental fuel
consumption or engine warning light illumination. In any such instance no
warranty is offered or implied by mountune.
WARNING:
This part has been designed and is intended for off-highway application only. Installation of this part on a vehicle that is driven on public roads may violate U.S. and Canadian laws and regulations relating to emission requirements and motor vehicle safety standards. Click Here for Emissions compliance information.